ZZPerformance

This is a replacement oil-resistant o-ring for our ZZPerformance catch can found in our LTG catch can kit, Sonic/Cruze PCV upgrade kit, and 3800 ca...

OEM GM original rod bearing for your 1.4 LUV/LUJ engine. These are standard sized bearings.  SOLD INDIVIDUALLY. You will need a quantity of 4 for a...

Permatex® Ultra Copper® 3 oz tube. OEM specified. Highest operating temperatures for 4-cylinder, turbocharged or high-performance engines. The mos...

These are replacement serpentine belts for your LTG engine.

Shift Solenoid for 4T65e transmission. Each trans uses two solenoids and they are interchangeable.

This billet aluminum piece will reinforce your rubber shifter end. It easily installs without causing any damage to your factory shifter cable end....

Shorten your shifter throw in 1 hour or less. Includes install instructions.  It works in F35 and F40 transmissions. Note: In the F40 transmission,...

Replace your stock dogbones with these 1" shorter replacements. Shorter dogbones will hold the engine forward, which has a few benefits as shown be...

Supports up to 350WHP supercharged or 400WHP turbo. They work with gas or E85, but we recommend 80's when using E85. These injectors require our in...

60# injectors for the 1.4t are only intended for full E85 high power builds. If you are running gas or flex you will want the 42# injectors found h...

Supports up to 350WHP supercharged or 400WHP turbo. They work with gas or E85, but we recommend 80's when using E85. All ZZP purchased injectors c...

We only recommend these for full bolt on E85 or turbo builds. Our Boost Referenced Fuel System is highly recommended to reduce fuel pressure at idl...

We only recommend these for full bolt with E85 or large turbo builds.  These injectors will support up to 300whp on E85 and nearly 400whp on gasoli...

80lb Injectors, normally used in E85 builds, it is recommended to have a boost referenced fuel system when running injectors this size. Select betw...

Slim line flow matched and balanced 60 pound injectors are for high HP applications where an aftermarket power adder is being used. These are good...

These will work great for E85 builds where huge fuel systems are required. These are high impedance injectors so they are plug and play. Slim desig...

Replace your stock couplers or use any of these couplers when creating a custom project.  The Northstar throttle body to MAF coupler is 3.75" strai...

This is the correct size belt for your Slingshot if you have the ATI Super Damper.

This is a replacement ZZP air filter for our Slingshot Cold Air Intake or Slingshot Turbo Kit. This air filter is proprietary to our ZZP Slingshot ...

If you are looking to go smaller than a 2.8 pulley on your 3800 or a 2.7 pulley on your LSJ, you will need this tool. It machines down the snout to...

This is a replacement for your factory hydraulic mount. It is made from solid rubber so it won't leak. It is meant as a factory replacement. For a ...

The Kappa platform (Solstice/Sky) has a common issue with overheating due to the hoses to the overflow tank. These are one way valves so when the c...

Model: You will need to measure your clutch disc to determine which flywheel is correct for your application.  The "GM Performance Clutch Kit" woul...

Fitment note: The FX250 and FX350 clutches are intended for the 215mm size flywheel, the race clutch only fits the 228mm flywheel. You can intercha...