ZZPerformance

This is a replacement gasket for your 2.0 LTG powered vehicle. This gasket sits in between the turbo inlet and the manifold. Fits: 2013-2020 Cadill...

This is a new aftermarket OEM replacement flywheel. This is great if you are doing a clutch install and would rather swap flywheels than wait while...

 OEM 2.2 replacement head gasket.  No special sprays needed for the OEM gasket.  

This is the absolute perfect clutch upgrade for your 2.2 or 2.4 liter. We start with a custom aluminum flywheel that has a bolt pattern for your 6 ...

New GM cylinder head to exhaust manifold gasket for 2.2 and 2.4 Ecotec engines.

Its time to get rid of those stock OEM axles that have the shaft machined to break under stress. Its time to not be afraid of breaking your axles o...

This is a complete set of rings for your LE5 with stock bore size pistons (88mm). These rings are intended for stock pistons. 

This is a 2.5" exhaust gasket. Typically used to mate the stock downpipe to the stock catback.

3 Bar MAP for Slingshot

3 bolt gasket for Pacesetter header to Pacesetter downpipe.

PERMATEX® Sensor-Safe High-Temp RTV Silicone Gasket Maker 27B. Formulated for oxygen sensor equipped engines. Temperatures range from -75°F to 650°...

This is our newest 3 gauge A-pillar pod for all 97-02 Grand Prix's, the only difference between the Gen 3 and 4 is this one moves the gauges closer...

New redesigned gasket that is reinforced on the inlet hole to prevent premature failures. 3 inch 2 bolt exhaust gasket (with 5.5" bolt spacing)....

This is an OEM oil filter for the 3.6L LF4 engine and models below: BUICK ENCLAVE 2011-2018 BUICK LACROSSE 2011-2018 CADILLAC ATS 2016-2018 ...

This is an OEM oil filter for the 3.6L LF4 engine and models below: BUICK ENCLAVE 2011-2018 BUICK LACROSSE 2011-2018 CADILLAC ATS 2016-2018 ...

Rated at 33 pounds (some refer to them as 36#). These are brand new L67 injectors. 12.2 Ohm, 354cc @ 3 Bar (33.71 lbs/hr @ 3 Bar)34.28 lbs/hr @ 45 ...

Rated at 33 pounds (some refer to them as 36#) and have the EV1 injector plug. These are brand new "L67" injectors that come out of the Supercharg...

This is what you will need to remove your factory harmonic balancer. It is also known as the crank pulley or damper. There are two separate kits, y...

This is a brand new replacement bypass valve for m90 blowers. We carry two version of this bypass valve; first being the GM M90 style with the sole...

Complete your aftermarket camshaft install with our ZZP cam install kit. The factory bolts on the 3800 are torque to yield and should be replaced w...

Replacement coil pack for your L26, L36, L32, and L67 3800 engine.   This is for one coil pack, you'll need 3 if you need want to replace all of th...

Coolant level sensor. OEM replacement

2 or 3 pin sensor. Make sure you are ordering the correct pin number for your vehicle.

This is a remachined and rehardend 3800 crankshaft. It comes ready to install with new main and rod bearings.This crankshaft is intended for the GM...